Greater Tulsa Area Classifieds Moderated Newsgroup > Sand Springs
> Industrial Equipment
> Industrial Electronics and Power Control
> Weg soft start motor starter 220-460 volts 3-30 amps
Weg soft start motor starter 220-460 volts 3-30 amps
New Surplus WEG Soft Start Motor Starter IS THIS THE CORRECT SIZE SOFT START FOR YOUR APPLICATION? - SEE WEG'S INFO AND SIZING CHART AT THE FOLLOWING SITE..... http://catalogo.weg.com.br/files/artigos/4-680.pdf
compact fully digital soft starter with a state
Its digital construction provides optimum
operation, diagnostics capability and full
Simplicity in set-up and operation is assured
since all parameters and set up selections
potentiometers . Status LED`s alert the user
of the operational status of the SSW05 .
Simplicity, ease of set-up, and the micro
size assures quick and easy installation and
208 480V, 50/60Hz input power supply
Duty cycle: 300% rated current during 10 seconds, 4
One digital input for Start / Stop (90 250 Vac)
One digital input for Fault Reset (90 250 Vac)
One relay output for Run indication (1 Amp 250V)
One relay output for Full Voltage indication (1 Amp
Adjustable acceleration and deceleration ramps
Adjustable pedestal voltage (30 80% of line voltage)
Protective features : Motor overload, over current and
locked rotor, SCR overload, phase loss and phase
Ambient : 32ºF (0º C) to 131ºF (55º), 3300ft
(1000m) altitude, 90% non condensing humidity.
IS THIS THE RIGHT SIZE STARTER FOR YOUR APPLICATION? - SEE THE SIZING TABLE AND OTHER INFO ON WEG'S WEBSITE AT : http://catalogo.weg.com.br/files/artigos/4-680.pdf
