Greater Tulsa Area Classifieds Moderated Newsgroup   >   Red Fork   >   Tools   >   Infrared smt smd bga rework station irda welder 862++

Infrared smt smd bga rework station irda welder 862++


Can suitable for all of the component,especially Micro BGA component.
1. Adopt infrared weld technology which independent exploration.
2. Use infrared heat,it is easy to cut through,heat proportion piercing tradition weld machine with sirocco.
3. Easily operate.Just need one day training.Can operation this machine.
4. No need weld tools,it can weld all the component of 15x15-35x35mm.
5. This machine has 650W heating system.widely to 120x120mm.
6. Infrared heating no have sirocco flow. Don't impact perimeter scomponent. Can suitable for all of the component,especially Micro BGA component.
Working voltage : AC220/110v 50/60Hz
As an China Wholesaler, we guarantee that they are at the lowest price and top quality!
①Check the power source,wind the plug.②Turn on the power source.Don’t use until pass check.Pand will display enactment value.When last time used.③Different lamp holder selection：The lamp body smallest facula diameter is 15mm, the biggest facula diameter is 50mm, may act according to the chip size selection different lens, The this aircraft has the diameterΦ28mm、Φ38mm、Φ48mm three lamp holders, the distinction is smaller than satisfiedly 15x15mm、15x15-30x30mm and big 35x35mm chip sealing off demand。After replaces the lamp holder, may act according to the chip size, the adjustment focusing knob.Causes the facula all to cover the chip is suitable.④According to measurement of welder piece.Proprictily screw temperature.from60℃-350℃.When you strip 15×15mm piece.Choice temperature 240-300℃.When you strip 25×25mm piece.Choice temperature 300-350℃.The temperature come up to 350℃.The light system will shoot straightly.Please pay more attention to yourself control time.avoid burn out.⑤Screw focus.The light system smallest diameter is 15mm .the biggest is 50mm.Normally keep 20-30mm.⑥Turn on the two switches.They control warm-up plate and light system.2、Dismantle and weld。①Regulate temperature , make the chip focus ②After suitable for timing, the tin is clicked and melted, take out the chip。3、Weld the chip。①Clean the pad。 ②Coating help solder flux (should not thick too , can have first more thin ) and soldering tin ball。 ③Wait to help the solder flux to volatilize into the flux, heat and totally melt to the tin ball , place correctly with the clip , aim at the chip to weld into the position.④936 searing-iron.Open the swich and enactment temperature.Caution! 1、After use , imprison power immediately , make sure the light body cooling down,and place it in safety.After turning off the power switch 2、Keep the blowing way without hindered, the light body is clean. 3、The support in good time is polished with the oil to lead the post , focus 4、Disconnect the plug when you don’t use the it for a long time. 5、Operate carefully, take care。
The mail will be sent out from Shanghai, China.
Thanks!！！！！！ Thank you very much!!！！！!!Because I am a new seller,If you didn\\\'t receive the goods as the problems on transportation,kindly please wait several days. i will give you a flavourable answer as soon as possible. Thanks very much!! ！！！！！！！！！！！！！！
Wholesales and foreign distributor are welcome.



Infrared smt smd bga rework station irda welder 862++